Hunter 26 mast lifting pole 101 3/8 inches

Mast Lifting Pole 101 3/8 Inches

Hunter used three different rigs over the production run of the 26 1993 - 1997 and each uses a different pole. Please inspect your mast for the name and model number of the manufacturer. Most will be Z-Spar or Isomat. This information is usually found near the base of the mast.

101 3/8" inches long made of stainless steel (Hunter switched from aluminum to stainless during the production run). Please note the pole we have listed is for the Z-Spar mast only as shown in the picture. If your mast Raising pole is different in any way please let us know before ordering, or if you have a different mast then a Z-Spar.

Enter the manufacturer and model number (if available) in the the comments box during checkout.

Shipping Note: Due to the length of this pole, it is classified as an oversize package. Shipping will run from $125 - $160 depending on where you are in the US. We will contact you with an actual shipping cost after we receive your order.

We're adding more parts daily. Can't find the part you need? Contact us.

Shipping time: see chart

Made to order: No

Please check to make sure the part you're replacing looks like the one in the photo. There may be small differences due to manufacturer upgrades and redesigns.