Serving sailors online since 1997
Hunter OEM Parts
General Marine Parts
 


Don't see the part you need? Contact us!

STANCHION WITH SEPARATE BASE AND WRAP-AROUND BAIL

Hunter used this stanchion design in the late 90s and early 2000s. (These do NOT fit boats with an aluminum toe rail from the late-80's to mid-90's, available here.)

These stanchion assemblies have a separate base with a wrap-around bail. The stanchion pole drops into the base.

These assemblies used at least three different bail sizes and some boats used a different size and angle on each stanchion. Compounding the problem, the bases were hand welded on a jig, so there are variations even within bails of the same size.

For all of these reasons, we are unable to sell the bases off the shelf and each one must be fabricated to your measurements.

Due to natural variation in hand-welded parts, the bail may need to adjusted up to 1/4 inch to meet the mounting holes in the deck. This can be resolved by bending the bail slightly at the time of installation.

Gate stanchions may also need to be adjusted to match the existing mounting holes.

The original bases and stanchions were drilled for a 10-24 bolt on the bottom and a set screw on the top. However, the new bases and stanchions are drilled for two 1/4-20 bolts, top and bottom. Because stanchions are critical safety equipment on your boat we strongly recommend that stanchions and bases be replaced in sets. The mounting holes will not match when using an original base with a new stanchion and will require you to drill new holes in the base.

After you order, you will receive a link to an illustrated measuring form. Measurements can be submitted online and once approved, we will begin fabrication.

We're adding more parts daily. Can't find the part you need? Contact us.
Fabrication Lead Time

This part is custom fabricated and is not shipped from inventory. Simple parts can sometimes ship within a week but if the shop is busy, lead times can run 2-3 weeks or more. We will do our best to expedite your order but we cannot commit to a firm delivery date. We appreciate your understanding!

Measurements required: A form will be sent to you after purchase

Leaves warehouse: 21 business days after measurements are approved

Shipping time: see chart

Made to order: Yes


Please check to make sure the part you're replacing looks like the one in the photo. There may be small differences due to manufacturer upgrades and redesigns.
Item No.PartStatusPriceQty
827433
H-305140
STANCHION BASE WITH CUSTOM WRAP-AROUND BAIL
26 units in stock, leaves warehouse in 21 business days
$189.95
800217
H-1035885
Gate Stanchion (two legs), 24 inches - STARBOARD FWD OR PORT AFT
4 units in stock, leaves warehouse in 3 business days
$124.95
827335
H-1037733
Gate Stanchion (two legs), 24 inches - PORT FWD OR STB AFT
3 units in stock, leaves warehouse in 3 business days
$124.95
800216
H-1035884
Post Stanchion (single leg), 24 inches
109 units in stock, leaves warehouse in 3 business days
$87.70
827393
STANCHION BASE FASTENER KIT (4 PAN HEAD SCREWS OF EACH SIZE)
3 units in stock, leaves warehouse in 1 business days
$7.99

 
Positive SSL